EDECMO Episode 11 – The Paris ECMO Course

Paris ECMO Course The excellent lecturer was Dr. Guillaume Lebreton, Associate Professor and Cardiothoracic Surgeon Director of the CPB and ECMO program, Department of Cardio-Thoracic Surgery Pitié Salpêtrière Hospital How Not to Frack Up DO NOT ADAPT TECHNIQUE TO YOUR CAPACITY Fixed Point for Wire–meaning wire must be held stationary as you dilate, otherwise dilator will back wall through vessel with anything but the stiffest guidewire. We get a false sense of security from smaller line placement. Discussed being fooled by echo They do cutdowns for all ECPR Inflow Crap flow if too small If you measure from the puncture site directly to the middle of the sternum, that should be your insertion. Too deep is better, with Maquet you want the tip in the RA 24-29 F with 25 being the sweet spot 55 cm Maquet for all adults When the holes are through the vessel, PULL Back the Dilator Outflow Hemolysis if too small 17-21 F for VA 19-23 F for VV IJ catheter length-15 cm on right, 23 cm on left Don’t pull back dilator for arterial placement Placement Pad behind buttocks to straighten vessels 4″ or so Needle bevel facing up and wire’s j facing up Gentle Angle for  Needle Placement Guidewire-go fast and it goes straight Always use the 150 cm guidewire. Leave 1 meter out, 50 cm in pt Scalpel-1 cm cut and plunge Doesn’t bother rotating the dilators VV-do the femoral first as it is harder to knock out Femoral-Femoral VV Return close to tricuspid, not multi-stage Drainage as central as possible, but in IVC, not RA Put in both guidewires first Put the longer cannula (return) in first Inflow-21-23 short insertion, but same length cannula (Maquet) Outflow-17-19, single stage (Medtronic) TroubleShooting If at the same speed, decreased flow–think thrombosis Starting VVECMO Clamp on tubing Start slow, 2000 rpm then slowly declamp Start sweep at 6 lpm (or 1:1 with flow) Go up to the max flow you can get at first to see your max You want to provoke reflow You should be able to get big flows (6-7 lpm) Dial Back to 5-6 Liters or 3 L/m2 (>60% of CO is what you should be aiming to capture) You should be able to get to 100% sat quickly If you are seeing recirc, pull back inflow slightly (max 1-3 cm) Treat the pt not the xray when it comes to cannula positioning Factors that increase Recirc Proximate venous tips Low CO Hypovolemia Increased pump flow rates Avalon Turn Head all the way to the left to align IVC and SVC VA FEM/FEM do venous 1st if doing cutdown Image by Cedric Lange

There are no comments yet.

Please log in to write the first comment.