Portland, Oregon. Autodesk Fusion 360 Academy Day 2. Sans the glitz, glam, and exuberance of Autodesk University Las Vegas, the close-nit vibe and Fusion focused course material makes for an amazing time. Saunders shares an AWESOME Fusion 360 hack from Rob Lockwood's 5-Axis Fixturing Course. IT'S A SMALL WORLD During the event, Saunders has dinner with Don Grant from Helical/HarveyTool, the same person Grimsmo met at Autodesk Toronto in July. Turns out, Don had a sweet solution for Grimsmo's 3/32 problem! TOOL MORTALITY...or IMMORTALITY (may be an exaggeration but...just go with it) During critical knife handle milling, 3/32 4-flute endmills were dying within 1 pallet, which means having to re-work each pallet (PAINFUL) BUT---the good news is the Helical 5-flute endmill coated for titanium has lasted through 17 PALLETS AND IS STILL GOING STRONG! NOT COOL, BRUH. AC gets repaired only to break down again two days later. Although the Nak LOVES the heat and is churning out uber-consistent parts...the lapping machine begs to differ! How's the TORNOS? An expensive coding mistake serves as reminder to quadruple check code AND make sure the post is smooth, refined, and operating without requiring manual manipulation. Home Sweet Home Grimsmo and FAM are moving into their first home! SHADOW PEOPLE The desire to see a day in the life of other shop owners has remained strong for Saunders, especially if he could do it in stealth mode. Everyone tends to change behavior slightly in the presence of company or a camera. Corncob, Triangles, & Toblerones The new tumbler that emerged from a trade deal has dividers. Erik tosses his SAGA into the corncob section to see how it holds up.

Ask this episode

“What did the council decide on item 42?” — answered with the speaker and the moment.

Transcript

Related