Voids in Bottom Termination Components

episode

Würth Elektronik Watts Up Podcast not yet transcribed

▲ 0

Transcript

This episode hasn't been transcribed yet Upvotes decide what gets transcribed next — 0 so far. Sign in to upvote

Related

recent transcribed audio

What Career Should You Choose in the AI Age? 32 min · 21 Sep 2026 · Merryn Talks Money

Global Stocks Rally 2 min · 21 Sep 2026 · WSJ Minute Briefing

Is Optimization...a Bad Thing? 1h 7m · 21 Sep 2026 · The Dave Chang Show

Would You Vote For A Muslim For Senate Or President? 23 min · 21 Sep 2026 · Politics By Faith w/Mike Slater

351: Matt's Moving to the Big Apple! (New York) 1h 23m · 21 Sep 2026 · Zane and Heath: Unfiltered

The Truth About Brain Rot 52 min · 21 Sep 2026 · Deep Questions with Cal Newport

Report any issue

Source

Recorded18 Nov 2021

Publisherwattsup.libsyn.com ↗

Handlerec:19109464

Show notes

The market for Bottom Termination Components (BTCs) is growing rapidly, but these components have brought new challenges in design and assembly processes. The large areas of the solder terminals bring many advantages with them, like dissipating heat of the component. However, if the assembly process is not properly adjusted, then this can cause voids under the component. In today's podcast, we'll discuss the work carried out to evaluate the challenges of voids on the WE-MAPI and other DFN products. Download the Application Note at www.we-online.com/appnotes or click here.

Ask this episode

“What did the council decide on item 42?” — answered with the speaker and the moment.

Sign in